Products

Coupler Set - 6 Space

$4.78

Coupler Set with Terminals - 6 space (Small round pin type)Part Number: 12-0629

Coupler Set - 2 Space

$4.78

Coupler Set with Terminals - 2 space (side by side) - Large Flat Spade typePart Number: 12-0631

Coupler Set - 2 Space (90 Degree)

$4.78

Coupler Set with Terminals - 2 space (at 90 degrees to each other) - Large Flat Spade typePart Number: 12-0632

Coupler Set - 3 Space

$4.78

Coupler Set with Terminals - 3 Space - Large Flat Spade Type. Set for stock factory TCI Ignition trigger wire to stock wire harness...

Coupler Set - 3 Space (Small Flat Spade)

$4.78

Coupler Set with Terminals - 3 space (Small Flat Spade type).Part Number: 12-0637

Coupler Set - 4 Space

$4.78

Coupler Set with Terminals - 4 space - Large Flat Spade type.Part Number: 12-0634

Coupler Set - 4 Space (Small Flat Spade)

$4.78

Coupler Set with Terminals - 4 space (Small Flat Spade type).Part Number: 12-0638

Sold out

Coupler Set - 6 Space (12-0635)

$4.78

Coupler Set with Terminals - 6 space (Large Flat Spade type). This coupler set connects the 1970-84 650 alternator to the stock wiring harness.Part...

Coupler Set - 6 space (Small Flat Spade)

$4.78

Coupler Set with Terminals - 6 space (Small Flat Spade type).Part Number: 12-0639

Sold out

Coupler Set - 8 Space

$4.78

Coupler Set with Terminals - 8 space (Large Flat Spade type). This coupler set connects the 1980-84 650 Rectifier/Regulator to the stock wiring harness.Part...

Coupler Set - 9 Space (Small Flat Spade)

$4.78

Coupler Set with Terminals - 9 space (Small Flat Spade type).Part Number: 12-0640

Crank Main Bearing - Left Hand

$151.19

Crank Main Bearing (Special Roller type) - 3 used per engine. - Located center (2) and Left hand side of crankshaft (1). OEM# 93390-00003-00...

Crank Main Bearing - Right Hand

$88.27

Crank Main Bearing - Drive end - RH (Ball Type) - B6306C3- Special. 1 Pc. used per engine. - Made in Taiwan. OEM# 93306-30604-00-00...

Sold out

Crankcase Breather Filter (15-0681)

$16.34

Breather Filter with rubber end. Washable type. 1-1/2” length - filter body 2” Outer Diameter 3/8" outer diameter on the inlet.Part Number: 15-0681

Sold out

Crankcase Breather Filter (15-0682)

$21.72

Breather Filter with Chrome Steel Ends.Part Number: 15-0682

Crankcase Top Bolt - Set/4

$12.04

Engine Crankcase Bolts (Set/4). Bolts fasten engine cases together and pass thru cases from the top of the rear portion of the engine. We...

Crankshaft Oil Seal

$14.46

Engine Crankshaft Oil Seal on Alternator (Left Hand) side. OEM Seal# 93102-25121/25090 Ars SD 25-40 9-L-1 HSPart Number: 01-9025

Crown Nut For Exhaust Mount Studs

$3.57

Crown Nut for Exhaust Mount Studs, OEM Ref.#95380-10800-00.Part Number: 49-0712

Cylinder Base Gasket - Stock Bore

$20.51

Base Gasket for Stock Bore (650cc) Cylinders. Stock type stud holes (dowel pins are used). Special chemically treated gasket material makes improved seal. (no...

Cylinder Guide Bar Bolt - Pack/2

$2.36

Chrome Cylinder Guide Bar Bolt (Pk/2). Bolt Passes thru cylinder guide bar nuts located at Front/center of cylinder casting and secures cam chain guide...

Cylinder Guide Bar Nut - Pack/2

$4.78

Chrome Cylinder Guide Bar Nut (Pk/2) Fits: into Front/center of cylinder casting on All 650's 1970-84.Part Number: 49-0722

Cylinder Head Crown Nut - 10mm x 1.25

$3.57

Cylinder Head Crown Nut - 10mm x 1.25, OEM Ref.# 90176-10008-00, 90176-10075-00.Part Number: 49-0700

Cylinder Head Gasket (18-0852)

$39.87

Gasket - Cylinder Head. (77.0mm), OEM Ref.# 306-11181-00. Fits: 1972-84 650'sPart Number: 18-0852

Cylinder Head Hardware Set

$72.54

Cylinder Head Hardware Set Fits: 1972-84 XS/TX 650'sPart Number: 49-0653

Cylinder Head Sealing Washer

$5.45

Cylinder Head Sealing Washer Steel Head washers with internal seal. Used under 4 outer cylinder head crown nuts. Note: Not included in gasket sets....

Cylinder Stud Installation Tool Set

$16.88

3 Piece Cylinder Stud Installation Tool Set. Installs studs without damaging the threads. Steel construction with black oxide finish for longer tool life. Includes...

Cylinder/Head Dowel Pins (Pk/2)

$13.25

Dowel Pins for Cylinder Head or Base - 14mm. OD x 16mm. Long. Fits: All 650's 1970-84Part Number: 05-0740

Damper Bolt Driver

$10.83

Damper Bolt Driver 8mm Hex - Deep type damper bolt driver used to air impact recessed damper bolts from lower fork legs.Part Number: 35-5022

Damper Bolt Sealing Washers

$3.03

Damper Bolt Sealing Washers - Copper (Pr.) - Fits under allen socket head damper retaining bolts (Lower fork leg to inner dampers). Fits: XS650's...

Damper Bracket - 34mm

$42.29

Alloy Bracket - For Fork tube end of our Hydraulic Steering Damper. Made in Japan For stock 34mm Forks.Part Number: 28-4014

Damper Bracket - 35mm

$42.29

Alloy Bracket - For Fork tube end of our Hydraulic Steering Damper. Made in Japan For stock 35mm fork tubes.Part Number: 28-4001

Damper Retaining Bolts - Pack 2

$5.99

Damper Retaining Bolt (Pk/2). Fits into lower fork leg to inner fork damper. Special size allen socket head. Fits: XS650's 1977-84Part Number: 18-5021

Damper Rubber - Pack of 2

$13.25

Damper Rubber - Rear Fender mounting bolt through point - Set of 2 OEM Ref.# 168-21639-00-00Part Number: 02-6526

Damper Rubber Footrest Set

$26.56

Damper Rubbers - ( Rider footrest mount bracket ) - Set of 4Part Number: 02-6527

Damper Rubbers

$10.83

Damper Rubber (2Pc. Set for 1 sidecover) Fits: To 1 3/8" wide upper hanger for Metal side cover as used on "Standard" models. See...

Decompressor Cable - Grey

$20.51

Decompressor Cable (Grey) - OEM # 306-26371-00-00 - Made in Japan. Fits: XS2 (1972), TX650 (1973)Part Number: 51-6504

Deep Allen Socket Screw Driver Set

$48.34

8 pc Driver Set for Allen Socket Screw. Hard to find deep 140mm Long bits ideal for reaching up inside lower fork legs and...

Deep Shock Mount Crown Nut

$3.57

Chrome Shock Crown Nut - Deep Type. 17mm hex x 10mm x 1.25 pitch x 21mm Long. Fits: Shock absorber upper studs on 74-84...

Sold out

Dellorto #65 Pilot Jet - Pack/2

$8.41

# 65 Pilot Jet - D1486-065 (Pr). Fits: Dellorto PHF36 Carbs (Kit XS# 48-7000). This is the size used in our Dellorto Carb kit...

Sold out

Dellorto Carb Float

$30.19

Carb Float as used in Dellorto PHF36 Carbs.Part Number: 48-7042

Dellorto Float Valve - #300

$10.83

#300 Dellorto Float Valve D8649-X300 (Needle & Seat Assembly). Fits: PHF 36 Dellorto Carbs.Part Number: 48-7044

Dellorto K5 Slide Needle

$8.41

K5 Dellorto Slide Needle. This is the size used in our Dellorto Carb Kit - XS#48-7000.Part Number: 48-7040

Dellorto Main Jet #135 - Pack/2

$8.41

#135 Main Jet - D64-135 (Pr). Fits: Dellorto PHF36 Carbs (Kit XS# 48-7000).Part Number: 48-7026

Dellorto Main Jet #137 - Pack/2

$8.41

#137 Main Jet - D64-137 (Pr). Fits: Dellorto PHF36 Carbs (Kit XS# 48-7000).Part Number: 48-7017

Dellorto Main Jet #140 - Pack/2

$8.41

#140 Main Jet - D64-140 (Pr). Fits: Dellorto PHF36 Carbs (Kit XS# 48-7000).Part Number: 48-7018

Dellorto Main Jet #142 - Pack/2

$8.41

#142 Main Jet - D64-142 (Pr). Fits: Dellorto PHF36 Carbs (Kit XS# 48-7000).Part Number: 48-7019

Sold out

Customer Login

Products

My Motorcycle

Categories

World Wide Shipping

Secure Payments

Why Purchase From Us?

Your cart