Valve Stem Seal (Sold each) Made in Japan - OEM Ref.# 341-12119-00/02

Cylinder Head Sealing Washer Steel Head washers with internal seal. Used under 4 outer cylinder head crown nuts. Note: Not included in gasket sets. Made In Japan. Sold each. OEM Ref.# 90210-10004

Brass Cylinder Head Washer Can be used as a substitute for stock cylinder head sealing washers (#01-0650). Used on four outer cylinder head studs. 22mm. OD x 10.5mm. ID x 4mm. thick Note: All Cylinder head fasteners should be re torqued on newly assembled engines after they have been run at full normal operating temperature.

Front wheel Oil Seal - (SD-28-47-7)

Front Wheel Oil Seal - Speedo drive side - (SDO-45-56-6).

Rear wheel Oil Seal - Right Hand Side - (SO-27-52-5)

Rear wheel Oil Seal - (SD-35-62-9) Rear wheel - Sprocket side (Left Hand)

Front Right Hand Wheel Oil Seal - (SD 25-47-7)

Front Left Wheel Oil Seal - (SD 60-72-7)

Clutch pushrod shaft Bushing Replaces original bushing inside of pushrod housing (transmission shaft) and brings clearances back to original. When stock clearances are too large the pushrod moves to the side and increases tearing stress on the pushrod seal.

Cam Chain Rivet Link Tsubaki BF05T Cam Chain. Made in Japan

Cam Chain Rivet Link Rivet Link - D.I.D. 219FTss. Fits: # 52-4008 Cam chain. Made in Japan NOTE: May not fit old original chains due to later chain dimension and design improvements made to strengthen cam chain.

Engine Oil Seal Kit 10pc Set Includes 2pc. of special triple lip cam seals. Included: Electric start to crank case seal, starter motor shaft seal, kick start seal, shift shaft seal, clutch push rod seal, transmission countershaft seal, upgraded cam shaft seals x2, Crank seal (alternator side) & tach drive seal.

Clutch Pushrod Oil Seal Made in Japan OEM Ref.# 93102-08094/08118 (SD - 8-25-6) Ars

Camshaft Seals - Pack of 2 (LH/RH) Seals have a running pattern and must be installed as Left Hand/Right Hand Sides, cannot be interchanged. Viton. OEM Ref# 93101-25044 Made in Japan (25-40-7)