Swingarm Pivot Bolt (Shaft) - Bolt with full size thread (replaces undercut original). Check your original for cracks at the threads.

Performance Progressive wound Front Fork Spring set 2 pc- Fits:XS650 1977-84 with stock 35mm. forks. Springs Improve handling while retaining OEM geometry. Stops front end droop and diving during braking while improving cornering stability. Progressive design combats bottoming in hard conditions by increasing resistance as spring compresses. 24mm Dia. x 525 mm long. for some models you have to take out the spacer. These springs dont fit some US models with adjustable fork plug ( similar like #27-4004 )

Fork Gaitors (Set/2) 1972-84 models. (Remove stock dust covers). Give your 650 that "British" look. Provides great fork protection. 1970 models had a lip piece on the lower triple tree on which to clamp the boot, for later models simply insert a piece of split rubber rad hose inside and clamp the upper part of the boot to the fork tube. We suggest a breathing hole be punched on a lower pleat also (face to rear) to allow venting of air.

Cap (Fork Tube Top Cap/Rubber Plug) - Pk/2

Cap (Fork Tube Top Cap/Rubber Plug) - Pk/2 -

Fork Tube Set (2) - Replace those Worn/Damaged Fork tubes with our New Tubes & restore your front end to proper function & appearance. OEM Ref.# 306-23124-60-00 34mm OD. Fits: XS2 (1972) and TX650 (1973)

Fork Tube Set(2) - Replace those Worn/Damaged Fork tubes with our New Tubes & restore your front end to proper function & appearance. Fits: TX650A (1974) and XS650B/C (1975-76) OEM Ref. # 533/371-23124 34mm. OD

Fork Tube Cap O-Rings (Pk/2) for 34mm Forks

Fork Tube Cap O-Ring (Pk/2) for 35mm Forks

Swingarm Needle Bearing Conversion Kit - Kit includes Needle Bearings & Hardened shaft. Made in Japan.

Replacement Shaft Needle Bearing for #28-1011 Conversion Kit.

Bronze Swingarm Bushings (Set/2) - Replace your plastic factory swing arm bushings! Improve your bikes handling.

Swingarm Grease Seal Set - Holds grease into bushings & shaft area of swing arm. Helps seal out water & dirt. If your bike has originals they should be replaced! (20+ years). Made in Japan.

Swingarm Bolt Grease Fitting - Replace original grease fittings with ones that fit to common American size grease guns. Fittings fit to ends of swingarm shaft (bolt). 2 required per bike. Fits: All 650's 1970-84

Chain Adjuster Set - Fits: 1974-84 650's