Clutch pushrod shaft Bushing Replaces original bushing inside of pushrod housing (transmission shaft) and brings clearances back to original. When stock clearances are too large the pushrod moves to the side and increases tearing stress on the pushrod seal.

Clutch Pushrod Oil Seal Made in Japan OEM Ref.# 93102-08094/08118 (SD - 8-25-6) Ars

Clutch Adjuster Cover - Chrome - Covers adjuster screw in LH crankcase cover. Fits: 1971-84 650's

Clutch Friction Plate Fit: All 650's 1970-84 - Sold Each - Order number of pieces required. 1980-84 models - use 6pc. 1974-79 models - use 7pc.. 1970-73 model clutch friction plates are No longer available but these later types can replace the originals! (6 friction and 5 steel drive plates were originally used). To use these late type friction plates remove the old clutch plate separator O-Rings (discard), and add 1 additional steel drive plate and replace all 6 old type thick friction plates with 7pc. of this new type friction plate.

Clutch Spring Screw Set - 12pc. - 6 Socket Head Bolts with Matching Sleeves. Fits: 1970-84 Clutch Hub

Needle Bearing with Thrust Washer for Rear of Inner Clutch Hub. Fits: All 650's If your clutch does not seem to release properly or if you have difficulty finding neutral when the engine is hot a worn bearing may be the reason. Our high quality multi-needle bearing assembly is a superior replacement for the original. Note: Bearing Part #39-6505 (OEM Ref.#93341-23504) consists of - 1. the circular bearing race and 2. one thin matching washer. Parts books and manuals show this as 1 part only (not 2 pc). The Clutch must be assembled in Sequence shown above - Bearing with its matching thin washer and then the thick clutch washer (thrust plate).

High Performance Clutch Springs - Set of 6 - Replaces/upgrades sagged original stock springs.

Steel Clutch Drive Plate Fit: All 650's 1970-84 - Sold Each - Order number of pieces required. 1980-84 models - use 5pc. 1974-79 models - use 6 pc. 1970-73 (use 5pc. OR 6pc. if the clutch is upgraded to late type friction plates. See friction plate listings for conversion info). Oem Ref.# 341-16325-01

Clutch Pushrod Bearing, 2 used in each 76-84 engine, (only 1 pc. required if long early 70-75 type clutch pushrod is used). Fits: 1970-84 XS/TX650's.

Clutch Pushrod (Short Outer Rod). Stock part for 1976-84 650's

Clutch Pushrod (Long One-Piece Rod). Replaces both inner and outer pushrod and outer ball bearing used on 76-84's. Provides more stable action and allows less wear of clutch pushrod seal (Note photo not to scale). Fits: 1970-84 650's. Stock original type for 1970-75 models.

Clutch Hub Lock Tab, Oem Ref.# 90215-19139. Fits: 1980-84 XS650's

Spring Washer for Clutch Hub Nut, Replaces OEM # 214-16119-00. Fits: 1974-79 650's

Clutch Hub Nut, Oem Ref.# 90170-18221/18089, 156-16174-00. Fits: All 650's 1970-84

Clutch Hub Cush Spring Repair Kit. Replace broken clutch hub cush springs with this kit. Includes 6 Cush springs and special bolts that replace hub rivets. Fits: 1970-84 650's