Washer, Oval Special-Signal Mount #18, OEM Reference #90209-08028.

Turn Signal Washer - Special Mount #9, OEM Ref: 90209-08098.

XS Performance Coil Tower Boots for XS Performance Green Coil #17-6810 or #17-6807 (Pk/2).

XS Performance Coil High Tension Lead Ends (Fit Inside Coil Towers), (Pk/2). Fits: XS Performance Green Coils #17-6810 or #17-6807

Chrome Point Cover Screw, OEM Reference #98980-06020-00.

Kick Starter Motor Housing O-Rings (Pk/2). These o-rings are for the kick starter only, not the electric starter motor. OEM# 306-81827-10, 306-81827-10-00.

Ultimate High Output Replacement Coil. Replaces stock factory Tci ignition coils.12 Volt. Primary resistance 2.45 OHMs. Secondary resistance 15ak OHMs 6.6mm mounting holes spaced at 102mm mounting holes center to centerWarning: Serious High Voltage Possible Output as high as 82 KvCaution! Do not operate or apply power to the ignition system with one or both spark plugs disconnected. Do not leave the ignition on with the engine not running. Warranty is void if operated with one or both spark plugs disconnected or if the ignition is left on with the engine not running.

Rear Short Stalk Signal Lamp. For those wanting signal lamps tucked in closer to the frame. 8 mm stud mount.

Resistor Type Spark Plug NGK - BPR7ES NGK Spark Plug with 14mm thread. BPR7ES. OEM: 5534. Resistor plug for radio interference. Used with caps without resistors. The equivalent to the NGK BP7ES but with a 5k ohm resistor to reduce RFI. Fits: TX650,TX650A, XS650B-K (1973-84)

Grommet Set (2) to fit into Cam/Breaker Covers. Set includes one grommet with a hole (points side) and one grommet without a hole (fits to advance unit side). Fits: All XS 650's - Use on all models with cam triggered ignitions (points & Pamco).

Grommet Set (2) to fit into Cam/Breaker Covers. Set includes two grommets without holes. Fits: XS 650's - Use on all Tci models (1980-84 factory ignition).

Bar Switch Assembly - Brake/Throttle (RH) Side - Black Replaces OEM Ref. #447-83963-00 Fits: TX650A 1974 and XS650B 1975 models (Dual Pull Throttle Cable Models). Note: Wires from this switch usually ran thru the handlebars. Our replica has a U channel in the housing that allows the wires to run outside of the bars (or inside). If the wires from the switch are to be run inside the bars it will be necessary to remove the end terminal coupler block and attach suitable end terminals to match your harness.

Ignition Switch with Keys - OEM Ref. # 256-82508-30/31, 366-82508-30

Battery Eliminator Capacitor Kit for XS650 PMA Charging System Use this capacitor in place of your battery when installing our XSCharge PMA kit for Yamaha XS650. This will convert your bike to a battery-less charging system with kick only starting. Dimensions: 2" x 3-5/8 NOTE: Designed for use with XSCharge PMA charging system with either OEM Points or Mechanical Advancer (Standard) PAMCO ignition systems. NOT for use with Electronic Advanced Ignitions. NOT for use with Boyer Bransden Ignitions. NOT for use with stock XS650 charging system components.